Replace your overheated factory intercooler with our 7.5″ race intercooler kit to get the most out of your N54/N55. We designed this kit to be one of the best performing, direct bolt on intercoolers available for your BMW with special attention to quality and performance while maintaining a reasonable price point. Our intercoolers allow for higher HP gains, mainly due to their ability to keep intake temps down while preventing heat soak which is a common problem with the factory intercooler. This results in a more power and increased reliability with reduced chances of pre-detonation & knock.
The most important component of any intercooler is the core. The core cools the charged air from the turbo before it enters the engine and the OEM BMW tube and fin intercooler is designed to support low boost levels and air flow. Once boost levels and air flow are increased, the OEM unit is easily overwhelmed and can not keep up with the cooling demands of a tune running more than OEM boost levels. This results in heat soak which will result in a power loss and a higher potential for pre-detonation in the upper RPM range.
We remedy this problem with our ultra high density 1000hp custom bar and plate core design which utilizes a staggered and offset internal and external fin pack. Our core has been carefully tuned to provide the the best intake temperature reduction while maintaining minimal pressure drop. Our bar & plate core is also much more durable than the OEM tube and fin core, with a better ability to withstand rocks and other debris. This intercooler was specifically designed for upgraded turbo cars running larger twin turbos or single turbos. This custom core is 1080 cubic inches in total and is 134% larger than the stock intercooler.
- Ultra High Desnity Bar & Plate Core
- 134% Larger Than OEM FMIC
- Cast Aluminum End Tanks
- Easy install, less than 2.5 hours